Deep Black for Polyester Textiles OnColor™ NIR Sortable Black Colorants Masterbatch Solutions for Mosquito Nets

Vents should be placed at the intersection of each 90° bend in the runner system off of the cold slug well and vented to atmosphere Black Specks Contamination • Purge barrel with general purpose PP • Verify correct nozzle is being used • Pull screw for cleaning Degraded/overheated material • Decrease melt temperature • Decrease injection speed • Use appropriately sized barrel Brittleness Degraded/overheated material • Decrease melt temperature • Decrease injection speed • Use appropriately sized barrel Gate location and/or size • Relocate gate to nonstress area • Increase gate size to allow higher flow rate and lower molded-in stress Burning Process related Mold design • Clean, widen and increase number of vents • Increase gate size to reduce shear Fibers/Minerals on Surface or Uneven Surface Appearance Melt temperature too low • Increase injection speed Insufficient packing • Increase hold pressure and time Flash Injection pressure too high • Decrease injection pressure • Increase clamp pressure • Increase transfer position Excess material volume • Decrease pack pressure • Decrease shot size Melt and/or mold too hot • Decrease screw speed Loose clamp • Reset mold height • Increase clamp tonnage Troubleshooting Recommendations Incomplete Fill Melt and/or mold too cold • Increase nozzle and barrel temperatures Mold design • Enlarge or widen vents and increase number of vents • Check that vents are unplugged • Check that gates are unplugged • Enlarge gates and/or runners • Perform short shots to determine fill pattern and verify proper vent location • Increase wall thickness to move gas trap to parting line Shot size • Adjust transfer position to 98% full Nozzle Drool Nozzle temperature too hot • Decrease nozzle temperature • Increase screw decompression Shrink Too much shrink • Increase cooling time Too little shrink • Decrease cooling time Sink Marks Part geometry too thick • Reduce wall thickness • Reduce rib thickness Melt too hot • Decrease nozzle and barrel temperatures Insufficient material volume • Increase packing pressure Troubleshooting Recommendations (continued) Sticking in Mold Overfilled cavity • Decrease injection rate and pressure • Decrease hold pressure • Decrease cooling time Mold design • Increase draft angle • Polish cores in direction of ejection Part is too hot • Increase cooling time Warp Process related • Increase cooling time • Increase pack pressure • Increase pack time Mold design • Inspect for non-uniform mold cooling Part design • Inspect for non-uniform wall thickness Temperature control unit incorrect temperature • Check settings • Inspect thermocouple Weld Lines Melt front temperatures are too low • Increase pack and hold pressure Mold design • Increase gate size • Perform short shots to determine fill pattern and verify proper vent location • Add vents and/or false ejector pin • Move gate location 1.844.4AVIENT www.avient.com Copyright © 2022, Avient Corporation.

Increase cooling time Black specks Contamination 1.

Styrene domain is stained black.

The ColorMatrix™ Amosorb™ product line currently offers a wide range of masterbatch grades that can be used to address the needs of different beverages or foods in terms of protection from oxygen ingress.

and is a certified Lean Six Sigma black belt.   Factors that could cause actual results to differ materially from those implied by these forward-looking statements include, but are not limited to: our ability to identify and evaluate acquisition targets and consummate acquisitions; the ability to successfully integrate acquired businesses into our operations, such as IQAP Masterbatch,

The color masterbatch carrier should be compatible with the overmold grade selected. Higher levels of regrind are tolerated in black materials.

The color masterbatch carrier should be compatible with the overmold grade selected. Higher levels of regrind are tolerated in black materials.

60940 PK PE MASTERBATCH

309947 BL PP MASTERBATCH